Advice on Bulkhead in Bronco

[KRGBRNCO]

I'm starting the rebuild of my 68. It has a bulkhead behind the driver seat, so this Bronco could be either a truck cab or the typical Bronco. I need to replace the floor as it's rusted out, and I'm trying to decide if I should install a front bench seat or a bucket seat. I do not see much value in bucket seats with a bulkhead separating the front from the rear, but does anyone know if the bulkhead is structural or can be removed? See image on the thread of the bulkhead.

I'm new at this and this is my first bronco project. The reason I am asking is because I only see a new floor part at Wild Horses with bucket seat attachments, not the bench. Any helpful knowledge would be appreciated.

 

[Dusty]

I've never owned one with the bulkhead but I was under the impression they just bolt-in, bolt-out?

 

[KRGBRNCO]

Yes it comes right off with bolts at the back sides and bolts at the front. I just wasn't sure if it played a structural role for the cab or other parts. I'll go with safe to assume it's only there for the truck cab and removing it fine.

Pic if you are curious about the bolt location.

 

[Dusty]

Yeah that's what I thought. The tub should be fine without it, as the majority of EB's didn't have it. BTW that thing has to be fairly rare, maybe sell it to fund more Bronco parts